BarUp 271599 Mode D'emploi page 5

Product descriptions
Upper of spout
Spout
Motor cover
Motor
Preparation before first use
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable). Keep the packaging for future
storage.
• Clean the appliance, see: Cleaning and mainte-
nance.
Operation
1. Make sure the switch is in "OFF" status.
2. Place the ice cubes into the container.
3. Cover the lid on the container so that the mag-
netic sensor is in contact with the end of the
safety arm.
WARNING: Any attempt to by-pass the safety
interlock and use the appliance without its lid
may cause personal injury and /or damage to
the appliance.
Container
Screw
Blade
Lid
Magnet
Microswitch
Connection
Safety arm
Electric box
PCB panel
Power cord
Bottom base
On-off switch
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
4. Start the motor by pressing down the switch to
"ON". Run the appliance to crush the ice in the
container ( It lasts about 30 seconds to finish
crushing ice cubes in full container).
5. Switch the motor off by pressing down the switch
again.
NOTE: Always wait until all components have
completely stopped before opening the lid.
GB
5