Temperature Display; Declaration Of Conformity - Technoline WT 3005 Manuel D'instructions

SA
Saturday

TEMPERATURE DISPLAY

The indoor temperature is automatically displayed within 3-8 minutes after setting up.
Press button to switch between the temperature display formats °C and °F.
POSITIONED METHOD
The bathroom clock can be positioned in 3 ways as desired:

Pull out the table stand brackets from the rear of the clock, place on table or desk as desired.

Hang on the wall by hanging hole.

Attach on a smooth place with suction cap.
Important note before using the suction cup

Make sure that the desired attachment surface is smooth and flat, as only on these surfaces
can the suction cup adhere firmly.

Make sure that the surface on which you attach your watch is free of dust and grease. To be on
the safe side, clean the surface beforehand with water and detergent. Dry the surface
thoroughly after cleaning.

The suction cup should also be cleaned slightly damp, without detergents and dried lightly
before pressing on it to give it a stronger grip.

Press the clock firmly again from time to time and check how tightly the clock is fitted, as the
suction cup can become loose after a while.

To release, carefully lift the suction cup by the edge so that air can get under it.
RESET
Press NEUSTART button to return to the default settings.

DECLARATION OF CONFORMITY

Hereby, Technotrade declares that this product WT 3005 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC. The
original EU declaration of conformity may be found at: www.technoline.de/doc/4029665030050
SPECIFICATIONS
Dimensions:
Power requirements:
Temperature measuring range:
Resolution:
SA SA
Ø 147 x 50 mm
1 x AA Mignon LR06 1.5V
0°C to +50°C (32°F to 122°F)
0.1°C/ 0.1°F
SA SA
9
ZA SO SO