Preparation For Use; Unpacking And Setup; Power Source - Electrohome EA1409 Guide De L'utilisateur

PREPARATION FOR USE

UNPACKING AND SETUP

• Carefully remove the unit from
the display carton and remove all
packing material from the unit
• Unwind the AC power cord and
extend it to its full length
• Unwind the FM Antenna wire and
extend it to its full length
• Place the unit on a stable, level
surface, close to an AC outlet,
out of direct sunlight, and away
from sources of excess heat,
dust, moisture, humidity, or strong
magnetic fields
• Raise the lid to expose the phonograph. The phonograph has been
secured for shipment with a transit screw. Use a coin or screwdriver to
TURN THE TRANSIT SCREW CLOCKWISE. This will allow the turntable
to "float" and turn freely
• Remove the opaque white plastic
stylus cover from the phonograph
stylus by sliding it in the direction of
the arrow.
• Discard the stylus cover.
• Remove the twist-tie that was used to
secure the tone arm during shipment.
• Release the tone arm lock lever.
• Connect the plug to your AC outlet, as
shown below.

POWER SOURCE

This system is designed to operate
on normal 120V 60Hz AC only.
Attempting to operate this system
from any other power source may
cause damage to the system, and
such damage is not covered by
your warranty.
Note: This system is equipped with a polarized AC power plug having one
blade wider than the other. This is a safety feature. If this plug does not fit into
your existing AC outlet, do not try to defeat this safety feature by altering the
wide blade to make it fit into your outlet. If this plug will not fit into your outlet,
you probably have an outdated non-polarized AC outlet. Have the obsolete
outlet changed by a qualified licensed electrician.
All manuals and user guides at all-guides.com
- 7 -
Transit Screw
Tone Arm
Lock Lever
Stylus Cover