AGV K-5 S Mode D'emploi page 16

1
3
1
16
2
4
2
3.2) Removing/Fitting ear cushion
In the manual bag there is a couple of ear cuchions to
be installed on the cheek pads (1).
The ear cushion is installed on the cheek pad cen-
tering its holes with the buttons on the cheek pad as
shown in the figures (2).
Then apply the cheek pad inside the helmet as de-
scribed above.
After mounting the ear cushion, it is like in above fig-
ure (4).
Proceed in the same way for the other side.
For removal, disengage the cheek pad from the but-
tons, remove the ear cushions and assemble again the
cheek pads.
Make sure that the cheek pads are properly fastened
to the helmet.
3.3) Removing/Fitting the chinstrap padding
To extract the padding, it is necessary to disengage
it through the push-button that is present on the chin
strap (1) and then extract it completely (2).
To install it, it is necessary to slide the padding on the
chin strap and then connect it to the chin strap through
the push button.