Uline SANITAIRE H-2665 Guide Rapide

H-2665
SANITAIRE
®
BAGLESS VACUUM
DAILY
Dirt Cup – Before each use, check the dirt cup and
1.
empty if needed.
2. Belt Condition – Check the belt for signs of wear.
Change the belt when it is loose or has cuts or
cracks. Refer to the diagram on the underside of the
base for proper installation of belt and brushroll.
3. Supply Cord and Plug – Check supply cord and
plug for any cuts or damage. If damaged, have
the supply cord and plug assembly replaced by a
qualified Sanitaire repair center.
4. Motor – If there are unusual sounds or if poor
performance occurs, the motor should be inspected
immediately by a qualified Sanitaire repair center.
WEEKLY
Dirt Cup – Inspect the dirt cup for any unusual wear.
1.
Replace any defective parts.
2. Brushroll Bristle Strips – Check the bristles for wear
once a week. The bristle strips should be replaced
when the bristles are less than 1/4 inch in length.
PAGE 1 OF 3
1-800-295-5510
uline.com
ROUTINE MAINTENANCE
3. Brush Roll Condition – Check for and remove any
4. Filters – Check the washable, reusable filters for clogs
MONTHLY
1. Cleaning – Inspect and clean the vacuum,
2. Electrical – Inspect the cord assembly for wear and
3. Handle – Check the handle assembly for tightness
4. Motor – A qualified Sanitaire repair center should
5. Filters – Check the washable, reusable filters for
Pour le français, consulter la page 3.
loose material, such as string or hair wrapped
around the brushroll.
and clean or rinse as needed. There are 3 filters on
this vacuum (dust cup, pre-motor and HEPA filter).
including the fan chamber and under the hood.
check for proper handle assembly.
and replace handle bolts if missing.
make a routine check of the motor every 6 months.
Inspect the motor immediately if there are any
unusual sounds or if poor performance occurs.
clogs and clean or rinse as needed. If the filters are
still dirty after cleaning or vacuum does not have
good suction, the filter(s) may need to be replaced.
Para Español, vea página 2.
0721 RH-2665