After Installation; After Installing This Navigation System - Pion AVIC-U310BT Manuel D'installation

Section

After Installation

05
After Installing this
navigation system
1 Reconnecting the battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (–) cable to the negative (–) term-
inal of the battery.
2 Start the engine.
3 Press RESET button.
Press RESET button on the navigation unit
using a pointed object such as the tip of a
pen.
4 Make the following settings:
= For details concerning operations, refer to
"Operation Manual".
1 Set the language.
2 Drive an unobstructed road until the GPS
starts receiving the signal normally.
3 Make some necessary adjustments.
! Setting the time
! Change other settings as you prefer
Note
After installing this navigation system, be sure to
check at a safe place that the vehicle is perform-
ing normally.
22
En
All manuals and user guides at all-guides.com