Potek PI3000-AP Guide D'utilisation page 3

6. Attach the other end of the wire to a
properly grounded location:
Vehicle: Connect to the chassis, unpainted
frame part, or engine block of the vehicle.
Fixed location: Connect to a ground rod
or other appropriately rated ground.
CONNECTING INVERTER CABLES
TO THE INVERTER
1. Locate the Positive and Negative
terminals on the inverter.
NOTE:Please use the cables we provided, DON'T use battery clamps.
2. From the POSITIVE (RED) and the
NEGATIVE (BLACK) terminals, remove
3. Place the POSITIVE (RED) ring
connector onto the POSITIVE
(RED) inverter terminal. Place the
NEGATIVE (BLACK) ring connector
onto the NEGATIVE (BLACK)
inverter terminal.
4.
top of each ring connector. Put a nut
over these and tighten.
+
• 4 •
4. OPERATING INSTRUCTIONS
1. Connect the inverter (see Connecting
Inverter Cables section.
2. Switch the inverter's ON/OFF switch
to the ON (I) position.
3. The GREEN LED indicator will light,
indicating the inverter is receiving
-
power.
4. Switch the inverter's ON/OFF
switch to the OFF (O) position. (The
the internal speaker may make a brief
"beep". This is normal.)
5. Make sure the device to be operated
is turned OFF.
6. Plug the device into the inverter's
AC outlet.
7. Switch the inverter's ON/OFF switch
to the ON (I) position.
8. Turn the device on.
9. To disconnect, reverse the above
procedure.
• 5 •