OK. OJU 102 Mode D'emploi page 14

Regularly check the power plug and power
6.
cord for damage. If the supply cord is damaged,
it must be replaced by the manufacturer, its
service agent or similarly qualified persons in
order to avoid a danger or injury.
7. Observe all safety instructions to avoid damage through improper use! Follow all safety
warnings on the appliance and in this instruction manual.
8. Keep this instruction manual for future use. Should this appliance be passed on to a third
party, then this instruction manual must be included.
9. No liability will be accepted for damage resulting from improper use or non-compliance
with these instructions.
10. Only use this appliance for its intended use. The appliance is not suitable for commercial
use. This appliance is only suitable for indoor and household use.
11. Before connecting the appliance to the power supply, check that the power supply
voltage and current rating corresponds with the power supply details shown on the
appliance rating label.
12. Never use a damaged appliance! Disconnect the appliance from the electrical outlet
and contact your supplier if it is damaged.
13. To avoid damaging to the power cord, do not squeeze, bend or rub it on sharp edges.
Keep it away from hot surfaces and open flames as well.
14. Lay out the cord in such a way that no unintentional pulling or tripping over it is possible.
Keep the appliance and its cord out of reach of children.
15. If an extension cord is used, its capacity needs to be suitable for the power consumed by
the appliance.
16. Do not operate the appliance with wet hands or while standing on a wet floor. Do not
touch the power plug with wet hands.
17. Do not open the appliance casing under any circumstances. Do not insert any foreign
objects into the inside of the casing.
18. Never use accessories which are not recommended by the manufacturer. They could
present a safety risk to the user and might damage the appliance. Only use original parts
and accessories.
19. For additional protection, we recommend the use of a residual current device (RCD) with
a tripping current not exceeding 30mA in the electrical circuit supplying power to your
appliance. The installation should be done by an experienced electrician.
20. Keep the appliance away from any hot surfaces and open flames. Always operate the
appliance on a level, stable, clean and dry surface.
21. Do not pull the power plug out of the electrical outlet by the power cord and do not wrap
the power cord around the appliance.
22. Connect the power plug to an easily reachable electrical outlet so that in case of an
emergency the appliance can be unplugged immediately. Pull the power plug out of
the electrical outlet to completely switch off the appliance. Use the power plug as the
disconnection device.
23. Always disconnect the appliance from the power supply, if it is left unattended and prior
to assembling, disassembling or cleaning.
24. Dry the appliance and all accessories before connecting to the power supply and prior to
attaching the accessories.
25. Clean the appliance thoroughly prior to using it.
26. Do not use the appliance if the rotating sieve is damaged.
OJU102_140515_V03.indb 13
All manuals and user guides at all-guides.com
13
EN
5/15/14 11:54