ALPATEC MG 1 Mode D'emploi page 9

All manuals and user guides at all-guides.com
notice MG1 27/02/06 15:09
DESCRIPTION OF VFD SCREEN
Your ice maker is with VFD colour display (Vacuum Fluorescent Display).
When ice is made, indicators (k) are flashing.
a. small
b. medium
c. large
d. X-large
e. Ice off
f. timer
g. ice tank full
h. lack of water
i. failure
j. hour
k. production on the way
TECHNICAL DATA
Capacity
Power
Voltage
Lay the machine on the horizontal line for 5hours before you first use it. Clean the machine before you
first use it or if you did not use it for a long time (how to clean it, see page 10).
To ensure good ventilation, leave a gap of 20cm around the product.
Plug the ice maker
HOW TO ADJUST LOCAL TIME?
Press button Hour (13).
Minutes are flashing. Use buttons + and – (14) to adjust (00 to 59).
Press button Hour (13).
Hours are flashing. Use buttons + and – (14) to adjust (00 to 23)
Press button Hour (13) once again to validate.
HOW TO MAKE ICE?
Note: stop the ice maker for 1h after 5 h working then start again if needed.
Open the front door (2). If it is the first time you use the ice maker, take the ice
spoon (8) out.
Fill water tank (4) with clean water, not exceeding 2,3 l.
Use button Sélect (11) to choose the ice cube size. Each time you press the button,
the size change according to the following: small -> medium -> large -> X-large -> small. Size can be
adjusted any time.
Press button Start / Stop (10). Production will start after 90s.
Page 9
k
a b c
15 to 18 kg of ice cube / day
160 W
230 V
USING
USING
9
j
d e f g h i