Transform QL063 Manuel De L'utilisateur page 7

Installation (continued)
INSTALLING THE FAUCET
NOTE: It is helpful to have a second person hold the
faucet in place while tightening the mounting nuts.
Please ensure that none of the supply lines are kinked
during installation.
- Connect the sprayer head (1) to the sprayer
head connector (2).
- Remove the gasket (3), metal washer (4),
and retaining nut (5) from the faucet.
- Install the faucet through the hole
in the sink .
- From underneath, secure the faucet to the
sink with the gasket (3), metal washer (4),
and retaining nut (5).
- Tighten the retaining nut (5) by hand until
it is snug . Use a wrench to tighten it down .
Gently tighten the two screws on the
retaining nut . Do not overtighten .
- Attach and hand tighten the supply lines
(not supplied) onto the water connectors
(6). Use two wrenches to tighten the two
ends together .
NOTE: Failing to use two wrenches can damage the
faucet and void the warranty. Do not overtighten.
- This faucet is equipped with standard
1/2" NPS male thread connectors that are
compatible with standard 1/2" FIP water
supply lines .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
All manuals and user guides at all-guides.com
Faucet body
Rubber gasket (3)
Retaining nut (5)
Screws
7
Sprayer head
connector (2)
Sprayer
head (1)
Faucet handle
Sink
Metal washer (4)
Threaded shank
Water connectors (6)
Water Connectors
1/2" NPS thread (6)
1/2" FIP water supply
line compatible
(not supplied)
CONGLOMKB .COM