SoFlow Lou Board 1.0 Manuel D'utilisation Original page 35

Pressure on lever to big or lever broke off
Lou Board doesn't respond
Remote control is beeping and the board doesn't
react normal anymore
Lou Board stops Motor overheating
automatically
Microcomputer of the board doesn't react
anymore
Lou Board doesn't Distance between board and remote control too
drive calm and/or big
unsteady
Control electronics and receiver might be moist
Not enough power
Light on the charger glows green, but board isn't
charging  plug or charging cord damaged
Light on the charger neither glows green nor red
Lou Board can't be Battery can't be fully charged, light on the
recharged charger glows red, doesn't change to green after
charging
Lamp on the charger neither glows green nor red
Calibrate the In case, LOU remote doesn't work properly
remote respectively, acceleration, break and ZERO point
are not accurate.
copyright by www.louboard.com
See your retailer, the remote
control probably has to be sent in
Plug in battery and see if the
board now responds
Recharge batteries
Let the motor cool down
Recharge or replace batteries
Decrease distance
Dry
Recharge batteries
Plug and charging cord needs to
be checked and possibly replaced
Check plug and power supply
Battery or charger damaged,
replace accordingly
Check plug and power supply
1. Joystick is on ZERO position
(not acceleration and break
position)
2. Press (long) pair/reset button
(at the back of the remote),
34
Flowpad Bedienungsanleitung
User Manual