Ultra Eco Instructions D'installation Et D'emploi page 10

SALT LEVEL ALARM
The electronic control panel is equipped with a salt level
alarm, that will periodically remind the user to check the
salt level inside the brine cabinet and to refill it with water
conditioner salt if necessary.
When the salt level alarm is activated, the following will
happen:
1. the backlight of the display will flash on/off, to attract
the users attention;
2. the display will show:
Check salt level
To reset push
After refilling the brine cabinet, simply push the down
button to reset the salt level alarm. If any other button is
pushed, the salt level alarm will be cancelled, but not
reset, meaning it will be activated again after the next
regeneration!
If the brine cabinet is refilled by the user with water
conditioner salt, before the salt level alarm is activated, it
is possible to reset the salt level alarm.
1. Press the scroll button repeatedly until the display
shows:
Salt Added?
To reset push
2. Push the down button to reset the salt level alarm.
EN - English
All manuals and user guides at all-guides.com
ELECTRONIC CONTROL PANEL
Page 10
PROGRAMMING INSTRUCTIONS
Before entering the programming mode, make sure that
the control valve is in the service mode.
1. Press the scroll button; the display will show:
Language:English
Press the up or down
•
language.
2. Press the scroll button again; the display will show:
Set time: 20:51
Press the up or down
•
of day.
3. Press the scroll button again; the display will show:
Set hardn.: XX°f
Press the up or down
•
hardness of the incoming untreated water.
button to set the
button to set the time
button to set the