Best WTT32I Serie Mode D'emploi page 17

8" ROUND
FLEXIBLE
METAL DUCT
DECORATIVE
FLUE
12. Measure and install section of flexible metal ductwork (included with
ANKWTT320 or ANKWTT326) to damper/duct connector and bottom of non-
duct plenum. Use duct tape to make all joints secure and air tight.
CAUTION
Do not use plastic duct.
13. Plug power cord into wall outlet.
14. Slide the upper decorative flue section into the lower decorative flue section.
NOTE
For non-ducted
applications, the
upper flue should
be oriented so the
louvers are towards
the ceiling.
15. Carefully place the
upper/lower flue
assembly into the
recessed area of
the hood.
16. Slide the upper
flue upward until it
is aligned with the
non-duct plenum.
The non-duct
plenum should
be inside the flue.
Secure the upper
flue to the non-duct
plenum using (2) 4mm x 12mm mounting screws.
NOTE
9-10 ft. ceilings may require Flue Extension Model AEWTT32SB depending
on installation height (purchase separately). Discard the upper and lower
flues supplied with your hood and replace them with Flue Extension Model
AEWTT32SB.
NON-DUCT
PLENUM
DUCT LENGTH
DAMPER / DUCT
CONNECTOR
- 17 -