Sealed Air TASKI swingo 4000 Mode D'emploi page 98

Malfunctions
Malfunction
Machine without function
Brush does not rotate
Poor suction performance Floor re-
mains wet Drain water is not
absorbed
Suction unit switches off
Insufficient cleaning solution supply
Brush unit or suction unit cannot be
turned off
96
Possible causes
Machine is switched off
Emergency stop button pressed
Main fuse is defective
Error code on the display
Immobilizer activated or fault in the
controls
Batteries discharged or battery char-
ger defective
Batteries defective
Brush drive switched off
Main fuse is defective
Motor rotates, brush does not
Suction unit switched on
ECO button pressed
Suction hose not connected
Suction nozzle not on the floor
Blades worn out
Suction hose or squeegee clogged
(e.g. pieces of wood, pieces of fab-
ric)
Suction filter clogged
Suction unit indicator lights up but
vacuum cleaner is not running
Recovery tank full
Recovery tank contaminated
Fresh water tank empty
Quantity of the cleaning solution is
set too low
Cleaning solvent button switched off • Press cleaning solvent button
Fresh water tank filter
Error in the electronic system or in
the control panel
Troubleshooting
• Turn the key
• Release the emergency stop but-
ton
• Check/replace fuse
• Contact your service partner
• Contact your service partner
• Sit down on the driver seat
• Load batteries
• Contact your service partner
• Contact your service partner
• Press Brush button
• Replace fuse
• Contact your service partner
• Drive belt defective
• Check if the tool is engaged
• Contact your service partner
• Press suction unit button
• Switch off ECO button
• Connect suction hose
• Check suction nozzle suspension
for functionality
• Replace blades
• Remove any foreign matter
• Remove any foreign matter
• Check fuse and replace it, if nec-
essary
• Fuse is OK, contact your service
partner
• Drain recovery tank
• Check fuse
• Check recovery tank and clean it, if
necessary
• Check fresh water tank
• Adjust cleaning solvent volume
with +/- buttons
• Filter
• Stop the machine using emergen-
cy stop
• Contact your service partner
Page
86
86
98
89
86
86
86
90
90
95
86
90
94
94
93
86
86
86