ZALMAN X3 Mode D'emploi page 8

8. Mounting the top fans
9. Mounting the front radiator
Caution
※ 280mm radiator can be problematic to install on the X3. Width of the radiator should be 140mm. If you wish
to use a radiator larger than 140mm please be sure to check the distance between the side of the radiator to
screw hole. If the distance is below 5.7mm you can install it to X3.
14
10. RGB LED Controller
ENG
Connector to
Gigabyte
Motherboard(3-Pin)
Connector to
other Motherboards (3-Pin)
Connector to
PSU
※ Caution
Be sure to plug in connector accordingly (◀ to V)
RGB LED Controller Position
Fans 1~6 / 3-Pin
- 4 Pre-Installed
GND
DC 12V
NC
Addressable LED 1~6 / 3-Pin
- 4 Pre-Installed
5V
12V
DATA
GND
※ Please make sure of the Pin qty and the direction of the
Addressable RGB connector before installation.
RGB LED Control Button / 2-Pin
- Connector to RGB LED Control Button
LED 7~8 / 3-Pin
- Connector to LED Strip Bar
5V
DATA
GND
Gigabyte Motherboard Sync / 3-Pin
- Connector to Gigabyte Motherboard
- Requires Motherboard that Supports RGB Sync
Other Motherboards Sync / 3-Pin
- Connector to Motherboard
- Requires Motherboard that Supports RGB Sync
12V
5V
Green
DATA
Red
GND
Blue
※ Caution: if Addressable 3 Pin connects to 12V header
instead of 5V header improperly, It may cause fatal damages to
the product by the overvoltage.
SATA Power / 15-Pin
- Connector to PSU
- Input : 5V, 12V
15