Other External Component Operations - JVC KD-G442 Manuel D'instructions

Indications
SUB.W FREQ *
6
Subwoofer cutoff
frequency
TAG DISPLAY
Tag display
AMP GAIN
Amplifier gain control
IF BAND
Intermediate
frequency band
* 6 For KD-G442/KD-G441: Displayed only when "L/O MODE" is set to "SUB.W."

Other external component operations

You can connect an external component to the
AUX (auxiliary) input jack on the control panel.
Portable audio player, etc
~
• You can also select "AUX IN" as the playback
source by pressing the SRC (source) button.
16
Item Selectable settings, [reference page]
( : Initial)
• LOW : Frequencies lower than 90 Hz are sent to the subwoofer.
• MID : Frequencies lower than 135 Hz are sent to the subwoofer.
• HIGH : Frequencies lower than 180 Hz are sent to the subwoofer.
• TAG ON : Shows the Tag information while playing MP3/WMA tracks, [12].
• TAG OFF : Cancels.
• LOW POWER : VOLUME 00 – VOLUME 30 (Select this if the maximum power of the
speaker is less than 50 W to avoid them from damaging the speaker.)
• HIGH POWER : VOLUME 00 – VOLUME 50
• AUTO : Increases the tuner selectivity to reduce interference noise between
close stations. (The stereo effect may be lost.)
• WIDE : Subject to the interference noise from adjacent stations, but the
sound quality will not be degraded and the stereo effect will remain.
3.5 mm stereo mini
plug (not supplied)
Ÿ
Turn on the connected component and
start playing the source.
!
Adjust the volume.
⁄
Adjust the sound as you want. (See
page 13.)
To check the other information while
listening to an external component
AUX IN Ô Clock