SIOUX RO2512 Serie Mode D'emploi page 3

HOSE AND HOSE CONNECTIONS
The air supply hose recommended is 3/8" (10mm) I.D. If an extension hose is necessary, use 1/2" (13mm) ID hose with couplings not less than 3/8"
(10mm) I.D. The tool inlet thread is 1/4" NPT.
LUBRICATION
For maximum performance and tool life, an airline lubricator, set to deliver 1 drop per minute. SIOUX No. 288 Air Motor Oil is recommended. If an airline
lubricator is not used, add 8 to 10 drops of air motor oil to the air inlet at the start of the day and run the tool for 10-20 seconds.
Do not over lubricate because excess oil may contaminate the surface being sanded.
MAINTENANCE
Water, dust and other airline contaminants can cause rust and vane sticking. After long idle periods, flush the tool with a few drops of oil and run for 10
seconds. This will help remove contaminants and reduce the formation of rust.
OPERATION
Speed of the tool may be adjusted by turning the regulator located near the air inlet.
INSTALLING BACKING PADS
Hold spindle nut with wrench.
Thread pad into spindle and tighten.
INSTALLING SANDING DISC
• PSA
Remove backing paper from sanding disc.
Center on backing pad and apply firm pressure.
• HOOK and LOOP
Center sanding pad on backing pad and apply firm pressure.
REMOTE VACUUM OPERATION
Attach vacuum hose from portable dust collection system to sander's vacuum swivel.
VENTURI VACUUM OPERATION
Press end of hose onto sander's venturi vacuum adapter. Place open end of bag over other end of hose, locating strings at the first few hose ribs. Wrap
strings around hose and tie securely.
RO2512-50SNP
RO2512-60SNP
RO2510-44FNC
Form ZCE756
Disconnect tool from air supply before installing or removing wheel or making any adjustments
Be sure the pad is the correct size for the tool.
A mismatch between tool and pad will cause excessive vibration.
SOUND AND VIBRATION READINGS
Catalog No. *Sound Pressure dBA
74.9
75.3
808
*per EN ISO 15744
WARNING
WARNING
*Sound Power dBA
86.5
86.9
92.0
*per EN ISO 15744 *per EN12096:1997
3
*Vibration m/s
2
2.1
2.3
9.17
Date 2015April10/E