Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 3 rubber inserts
- 3 screws BHc Ø5x15 black (big head)
- 2 screws BHc Ø5x15 (small head)
- 3 rubber washers Ø5
Assembly
1. Fitting brackets mounting on the rear fairing.
- Provide yourself with the inner shell, the 3 rubber inserts and 2 threaded fasteners Ø5. Place them as indicated on the photo.
- Provide yourself with the rear fitting bracket, the 2 screws Ø5x15, the 2 Nylock nuts Ø5 and the 2 steel washers Ø5. Fit the
bracket as indicated on the pictures.
- Provide yourself with the front fitting bracket, the 2 screws Ø5x10 and the 2 rubber spacers. Fit the bracket and the spacers as
shown on the photos.
2. Seat cover mounting on the inner shell.
- Provide yourself with 3 screws BHc 5x15 (big head) and 3 rubber washers Ø6. Place a rubber washer on each screw. Place
the seat cover on the inner shell as in the photo, without tightening the 3 screws.
- Mount the seat cove on the bike. Proceed with its adjustment, and then tighten completely.
You can clip the seat cover thanks to it. However, if the oblong holes on the seat cover are not sufficient, you can
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
- 2 threaded fasteners Ø5
- 2 Nylock nuts Ø5
- 2 fitting brackets
- 1 inner ABS part
The space between the original fairing and the seat cover's tip at the back is normal and necessary.
adjust the front bracket by loosening it slightly and moving the threaded fasteners.
FITTING INSTRUCTIONS
ADAPTABLE ON SUZUKI GSR 750 2011→ ∞
- 2 screws BHc Ø5x10 (small head)
- 2 steel washers Ø5
- 2 rubber spacers
« CAUTION »
ERMAX SEAT COVER
Estimated fitting time 30 min
Publicité
