Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
FAUCET AND SPRAYER INSTALLATION
Before installing, carefully unpack the faucet and ensure no parts
are missing .
1 .
Feed the hose through the neck of the faucet if not pre-
assembled .
2 .
From underneath, slide the rubber gasket and retaining nut
over the end of the faucet shank, tighten the nut by hand
until it is snug .
3 .
Connect the hose end to the outlet .
4 .
Connect the water supply lines (not supplied) to the faucet .
5 .
Install the weight a couple of inches from the bottom of the
hose on the side closest to the faucet head . There should be
no slack in the hose .
Faucet shank
Base plate
Rubber gasket
Retaining nut
Weight
Water Supply Lines
All manuals and user guides at all-guides.com
STRAINER INSTALLATION
1 .
2 .
3 .
4 .
Faucet head
Outlet
Sink
Hose end
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Apply a ring of sealant to the underside of the strainer
flange.
Insert the strainer body into the sink .
Assemble the rubber gasket, friction washer and locknut
onto the strainer body from under the sink .
Hand tighten the locknut . Do not over tighten locknut as it
may split or deform the body of the strainer .
Sealant
Basket
Strainer body
Rubber gasket
Friction washer
Locknut
CONGLOMKB .COM
Publicité
Chapitres
Table des Matières
