Marmitek Stream S1 Pro Manuel page 4

Safety instructions
Please read these instructions thoroughly
before you use the device and keep them for
future reference.
This product is not a toy. Keep out of reach
•
of children.
Repairs or service should only be
•
performed by qualified personnel.
Step 1: Installing the Stream R1 Pro
(receiver)
1. Plug the HDMI stick into the HDMI input of
the display or projector. If necessary, use the
optional HDMI extension cable for optimal
placement.
2. Use the Micro USB cable as power supply
for the Receiver by plugging it into a free
USB port of the display or projector.
Receiver LED status:
Blue (blinking) – waiting for connection
Blue – connected
Step 2: Installing the Stream T1 Pro
(transmitter)
1. Plug the HDMI stick into the HDMI output
from the source (e.g. laptop or any other
HDMI device).
4
2. Some source devices can supply enough
power through HDMI output to the
Transmitter. In case the LED remains red,
use the USB-C adapter (or micro-USB cable)
to provide the transmitter with extra power.
3. If necessary, use the optional HDMI
adapter (male > female) for optimal
placement and installation.
Transmitter LED status:
Red – starting up
Red (blinking) – searching for Receiver
Blue (blinking) – waiting for connection
Blue – connected
Purple – no supported video signal
© MARMITEK