Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
FAUCET AND SPRAYER INSTALLATION
Before installing, carefully unpack the faucet and ensure no parts
are missing .
1 . Insert the spray housing support through the pre-drilled
hole on the sink corner . Screw the nut onto the threads and
hand tighten .
2 . Run the spray hose down through the spray housing and up
through the centre faucet mounting hole . Connect the spray
hose to the faucet and tighten with a wrench .
3 . Install the new faucet on sink with hot "H" to the left and
cold "C" to the right . From under the sink, thread mounting
nuts and rubber gaskets onto the faucet shanks and tighten
the mounting nuts .
STRAINER INSTALLATION
1 . Apply a ring of sealant to the underside of the strainer
flange.
2 . Insert the strainer body into the sink .
3 . Assemble the rubber gasket, friction washer and locknut
onto the strainer body from under the sink .
4 . Hand tighten the locknut . Do not over tighten locknut as it
may split or deform the body of the strainer .
Faucet shank
Rubber gasket
Faucet shank nut
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Sprayer and hose
Faucet
Sprayer housing
support
Nut
Sealant
Basket
Strainer body
Rubber gasket
Friction washer
Locknut
CONGLOMKB .COM
Publicité
Chapitres
Table des Matières
