Installation Procedure - Toto REAH03B1U Manuel D'installation Et D'utilisation

Table des Matières

Les langues disponibles

Install the Spout

To Install Deck-Mounted models

Secure the spout to the countertop with the included mounting hardware.

Make sure that the spout is mounted with the head directed towards the center of the lavatory.

To Install Wall-Mounted models

Reinforce the wall area behind the spout

NOTE

installation location. The addition of

2×4 stringer is highly recommended.

1. Place mounting template on wall at

desired location and mark holes.

2. Drill a 5/8" (16 mm) diameter hole at

the spout mounting location (center).

3. Drill four pilot holes at marked locations.

For fastening to wood, drill holes Φ7/64" (2.7 mm).

For fastening to drywall or tile, drill holes

Φ3/16" (5 mm) and insert anchors until

flush. Tap lightly with a hammer if needed.

To Install Libella and Axiom Wall-Mounted models

4. Place mounting bracket against wall and

fasten securely with the provided screws.

5. Pass the hose and sensor cord through

the mounting bracket respectively.

6. Tighten the set screw with the provided

2.5 mm hex wrench from the bottom to

secure the spout to the mounting bracket.

To Install Helix Wall-Mounted models

4. Feed the hose tube and sensor cord through

the 5/8" (16 mm) hole in center. Place spout

against wall and fasten securely with

the provided screws.

5. Pass the escutcheon over the spout.

6. Fasten the escutcheon to the bracket until hand-tight.