Publicité
Les langues disponibles
Les langues disponibles
Read all instructions before using or installing this product.
Technical data
– Supply voltage:
– Required electrical outlet:
– Max. power consumption:
Prod. No.:
- 24202 171351:
- 24203 171351:
Maximal load each shelf:
Maximal load mirror cabinet total:
- 24202 171151:
- 24203 171251:
– Degree of protection:
– Ambient conditions:
Operating temperature
Storage temperature
– Luminous color
Mounting dimensions, see page 8.
Included items, refer to picture 1 on page 9.
Wiring diagram, refer to picture 2 on page 9
The product can be operated in two ways.
Operating mode 1 (condition as supplied):
Light on/off on rotary dimmer of the product
(automatically off after power reinstated).
Operating mode 2:
Light on/off on external light switch (automatically
on after power reinstated).
To toggle the operating mode, press and hold
the rotary dimmer 15 seconds while the light is
switched off . The light turns on briefl y to confi rm
the change to the operating mode.
Lighting modes
The product has 3 diff erent lighting modes.
Mode 1: Front illumination
Mode 2: Washbasin illumination
Mode 3: Front and washbasin illumination
Press the rotary dimmer for at least one second to
change the lighting modes.
Before installation check whether the fastening materials
included are suitable for the anchoring base. The fas-
tening materials are suitable exclusively for stud walls
with timber constructions or for drywall constructions with
timber wood reinforcement.
120V AC 50Hz/60Hz
15 A / 1800 VA
Width
Weight
Light
22 W
25-9/16"
41.0 lb
24 W
31-1/2"
48.7 lb
max 3.3 lb
54.2 lb
61.9 lb
NEMA 1
32° – 113° F
-40° – 158° F
3000 Kelvin
Installation
• Do not remove protective edge before mounting
the top light, see picture 3 on page 10.
• Mark the wall bracket position, see picture 4.
• Mount the wall brackets to the wall, see picture 5.
• Hang the mirror cabinet on the wall from above,
see picture 6.
• Draw holes for fi xing screws, see picture 7.
• Remove mirror cabinet, see picture 8 on page 11.
• Drill holes and insert wall plugs, see picture 9.
• Connect the mirror cabinet to the power supply,
see picture 10.
• Hang the mirror cabinet on the wall from above,
see picture 11.
• Insert sleeves, screw in screws and cover with
caps, see picture 12.
• Place the glass shelf holders in the mirror cabinet,
see fi gure 13.
• Place the glass shelves in the mirror cabinet,
see fi gure 14 on page 12.
• Adjust the doors of the mirror cabinet, see fi gure 15,
16 and 17 on page 12 and 13.
Operation, refer to picture 18 on page 14.
Note: When switching off the lights, the type of
lightning and its intensity are saved and will be
the same after switching on the lights again.
Replacement parts with order numbers, see page 15.
The light sources may only be replaced by the
manufacturer, its customer service or by an
equally qualifi ed person.
For information about warranty and mainte-
nance, see the enclosed Care Instructions and
Warranty Card.
Disposal instructions
This category of device does not belong in
the domestic waste, but must be disposed of
separately in accordance with the relevant local
national regulations.
3
Publicité
