RocHobby Mogrich Manuel D'utilisation page 4

[1] A/B Mode switch key
[2] Re-set button（F.Reset）Mode A
[3] Steering Trim+（ST TRIM+）Mode A
[4] Steering Trim-（ST TRIM-） Mode A
[5] Power Switch
Reverse key mode a
[6]
/ steering angle limit mode B
In the use of the
disorder settings, not
back to the normal
F.Reset
state, you can use
Factory.Reset function
After replacing the
steering gear, the
steering gear is
reversed
After replacing the
motor, there is a
reverse
REV
Adjust 30 / 50 /
100% steering
radian
When the steering
ST TRIM
center is not centered
When the throttle is
TH TRIM
not centered
LED Light setting
[7] Throttle trim + (TH TRIM +) mode A / light control switch 1 mode B
Throttle trim - (TH TRIM -) mode A / light control switch 2 mode B
[8]
[9] Channel 6 (reserved)
Steering wheel
[10]
Throttle trigger
[11]
A/B mode function toggle switch
Make sure that the mode function toggle switch is in mode A, hold the
steering wheel left or right, and click the F. Reset button at the same time.
After two clicks, it means that the factory settings have been completed.
Make sure that the mode function toggle switch is in mode A, twist the
left or right steering wheel, and click Rev button at the same time. After
ringing, it means that the reverse setting of steering gear has been
completed.
Make sure that the mode function toggle switch is in mode A, pull or
push the throttle, and click Rev button at the same time. After ringing, it
means that the motor reverse setting has been completed.
Make sure that the mode function toggle switch is in mode B, and click
the ST Angle key. After a click, it means that the 30% steering radian
has been set. Click the ST Angle button again, and you will hear two
beeps, indicating that the setting of 50% steering radian has been
completed. Click the ST Angle button again, and you will hear three
beeps, indicating that the 100% steering radian has been set. Then click
to cycle to a click to indicate that the 30% steering radian has been set.
Make sure that the mode function toggle switch is in mode A, press ST
TRIM+ or - button to fine tune the steering center. Every click of the
button will ring. When the maximum and minimum values are reached, a
long sound will appear. When the median value is reached, it will ring
twice.
Make sure that the mode function toggle switch is in mode A, press TH
TRIM + / - button to fine tune the throttle center. Every click of the
button will ring. When reaching the maximum and minimum value, the
button will ring, when reaching the median value, the button ring twice.
One-button for multi-mode switch
2
EN