Additional Safety Instructions - ITC IPT-700V Guide D'utilisation

ADDITIONAL SAFETY INSTRUCTIONS

● When the tool is in operation, keep hands away from the polishing area.
● Always hold the tool with both hands.
● The polishing pad will not come to an immediate stop when the tool is turned off. Exercise caution.
● Do not put the tool down after use until the polishing pad has stopped rotation completely.
● Use only polishing pads that are rated for a maximum speed of 3,000 rpm or greater.
● Use only polishing pads with the correct bore to match the spindle size of the tool.
● Keep the power cord well away from the polishing area during use. The cord can be picked up by
the bonnet and wrap around the spindle quickly. Take care to position the cord in such a way as to
preclude it being caught on something while the tool is in use.
WARNING - The warnings, cautions, and instructions detailed in this manual cannot cover all
possible conditions and situations that occur. It must be understood by the operator that
COMMON SENSE AND CAUTION ARE FACTORS that cannot be built into this product,
but MUST BE SUPPLIED BY THE OPERATOR.
SPECIFICATIONS
BUFFER / ANGLE POLISHER
● Electronic variable speed: 1,000 - 3,000 RPM, rated speed
● 20 volts, 60 Hz, 10 amps
● 5/8" x 11 tpi spindle
● 7" diameter backing pad
● Tool weight: 3.2 kg (7.0 lb)
● Easy to set thumb wheel speed adjustment
● D-shaped auxiliary handle allows many comfortable hand positions
● Safety trigger prevents accidental start ups
● Metal gear housing
CONTENTS AND ASSEMBLY
CONTENTS
● Polisher unit
● D-handle
● Polishing backing pad
● Hex wrench
● 2 Hex socket head screws
● Polishing bonnet
ASSEMBLY
WARNING - Be sure the tool is not connected to the power supply before attempting assembly.
1. Position the D-handle (C) on the metal gear housing at the front of the tool.
2. Thread the two hex socket head screws (G) into the threaded holes on either side of the tool.
3. Using the supplied hex wrench, tighten the screws in place.
4
!
!