Sebson SET 6 R UNDER Mode D'emploi page 6

This product is only suited for indoor-use and not for outdoor-use!

 For mounting the lamp, choose a stable mounting surface that can support the weight of the lamp. The
manufacturer is not liable for damage caused by the use of an unsuitable mounting surface!
Install the lamp on a dry and non-conductive surface!

 This product is suitable for mounting on normally flammable surfaces!
Plan a minimum distance of 50cm between the illuminated area and the lamp.

To prevent damage to the cables, they must not be strongly bent, pulled or twisted during commissioning!

Technical Data:
Operating voltage:
Nominal wattage:
Nominal luminous flux:
Rated color temperature:
Electrical protection:
Protection class:
Nominal- / rated lamp life time:
Switching cycles:
This product contains a light source of energy efficiency class G.
Disposal note:
This product may not be disposed of with household waste. At the end of its useful life, the product must be
returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local
municipality for the point of acceptance! As the devices contain valuable recyclable materials, they should be sent
for recycling, in order not to harm the environment or human health from uncontrolled waste disposal.
Cleaning:
Before cleaning, disconnect the product from the power supply by pulling the power plug out of the socket!
Danger :
Use a slightly moistened cloth for cleaning. In order not to damage the product, it is essential to avoid water
penetrating into the housing! Never clean the device under running water! Do not use solvent-containing cleaner for
cleaning. Do not use solvent-containing cleaner for cleaning!
SEBSON
Sebastian Sonntag
Gernotstr.17
44319 Dortmund
Germany
support@sebson.de
VAT-Nr.: GB179436663
WEEE-Reg.-ID.: 500617
Mode d'emploi
Merci d'avoir fait l'acquisition d'un produit de la marque SEBSON. Avant la mise en service, lisez attentivement ce
mode d'emploi et conservez-le pour toute consultation ultérieure ! Un fonctionnement de longue durée et sans
défaillance ne peut être assuré que si l'installation et la mise en service sont effectuées en bonne et due forme.
Contrôlez la présence de dommages extérieurs sur le produit avant sa mise en service ! En cas de dommages
12V DC
6 x 2W
6 x 130lm
3.000K
IP20
III
>25.000h
>15.000
6