Fujitsu STYLISTIC Q552 Guide D'utilisation page 33

Replacing the Pen Tip
With use, the pen tip may become worn or may pick up foreign
particles that can scratch the screen. A damaged or worn tip may
not move freely, causing unpredictable results when using the pen.
If a problem like this should occur, you should replace the pen tip.
Pull the tip from the barrel.
1
Using one of the new tips that were supplied with your pen,
2
insert the pointed end of the tip into the barrel and push it in
firmly until it is in place
Installing a Pen Tether
To prevent dropping or losing your pen, you should attach it to your
system using the pen tether that is included with the system.
To attach the pen tether to your Tablet PC, perform the following
steps:
Attach the end of the pen tether with the smaller loop to your
1
pen. To do so, push the end of the tether under the slot on the
top of the pen, then thread the opposite end of the tether
through the loop.
Attach the end of the pen tether with the larger loop to the
2
attachment point on the right side of your tablet. To do so, insert
the end of the pen tether through the attachment point, then
feed the pen through the large loop in the tether.
32 - Active Digitizer/Touchscreen
Pen Tip
Figure 12. Replacing the Pen Tip
Figure 13. Installing a Pen Tether