Wolf ICBVS24 Guide D'installation page 5

I NSTAL L AT IO N
Preparation
Remove and recycle packing materials. Do not discard the
package containing the two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
the screws are adequately secured and do not penetrate
electrical wiring or plumbing.
IMPORTANT NOTE: The installation hardware is provided
with the accessory front panel.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Installation
Turn off power to the electrical outlet.
1
Place the unit on a protected work surface and remove
2
the two shipping screws from the back of the unit. Refer
to the illustration below.
Place the unit near the opening and plug the power cord
3
into the receptacle.
Slide the unit into the opening.
4
Open the drawer to full extension.
5
Drill a pilot hole in each mounting hole location. Refer
6
to the illustration below.
Secure the unit with the provided screws.
7
Turn on the electrical supply to the outlet and verify
8
operation.
SHIPPING MOUNTING
SCREWS HOLE
Shipping screw location Mounting hole location
TRO U BL E S HO O T ING
Troubleshooting
IMPORTANT NOTE: If the vacuum seal drawer does not
operate properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the unit.
• Verify proper electrical connections.
• If the vacuum seal drawer does not operate properly,
contact Wolf Factory Certified Service. Do not attempt to
repair the appliance. Wolf is not responsible for service
required to correct a faulty installation.
|
wolfappliance.com 5