Technische Gegevens - Vetus WPANEL Manuel D'utilisation

Technische gegevens

Voedingsspanning
12 Volt of 24 Volt gelijkspanning
Opgenomen stroom *) : ca 10 mA
Aantal wissers: maximaal 5
Maximaal vermogen ruitenwissermotor:
120 Watt
Interne zekeringen
Ruitenwissermotoren : 10 A (5 x )
Ruitensproeierpomp of –klep : 5 A (1 x )
Schakelaars
Wisserschakelaar:
Functie: ON – OFF (1 x maakcontact)
Functieschakelaar:
Functie: MOM – OFF – MOM
(2 x maakcontact, terugverend naar de
middenstand) + lamp
*) N.B. Alleen de regeleenheid, exclusief
het stroomverbruik van de ruitenwisser-
motoren.
Windscreen wiper controller
NEDERLANDS
Introduction
Using this windscreen wiper controller, a
maximum of 5 wipers can be synchroni-
sed at low and high speed as well as in
interval settings. The windshield wiper
controller is also equipped with an auto-
matic wipe/wash function. A maximum of
3 rain sensors can also be optionally
connected.
The windshield wiper controller consists
of a controller unit and a 6-switch panel to
be built in. The controller unit is suitable
for both 12 and 24 volts. Each output can
have a maximum load of 120 W and is
protected against overloading.
The windshield wiper motors to be used
must have 1 or 2 wipe speeds and an
automatic park setting.
WPANEL is delivered with:
1 x Controller unit
5 x Wiper switches
1 x Function switch
1 x Panel for 6 switches
2 x Blind panels
2 x Cable spade
1 x DIN Rail TS35
1 x Manual
Operation
Wiper switch
Each wiper (windshield wiper motor) has
its own switch. The switch is used to turn
the relevant wiper on or off. When a wiper
is switched on, it follows the selected
programme.
ENGLISH
5
101002.01