Déclarations De Conformité; Fcc - Elatec TCP3 Manuel D'utilisation

7 DÉCLARATIONS DE CONFORMITÉ
7.1 EU
TCP3 is in compliance with the EU directives and regulations as listed in the respective EU declarations of conformity (cf. TCP3 EU
Declaration of Conformity and TCP3 POE EU Declaration of Conformity).
7.2

FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been designed for Commercial Use only and has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules.
Caution
Changes or modifications made to this equipment not expressly approved by Manufacturer may void the FCC authorization to operate
this equipment.
Warning
This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
7.3 IC
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme à la norme CNR 210 d'Industrie Canada. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage ;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
Note
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
© 2022 ELATEC GmbH – TCP3 user manual DocRev3_FR – 03/2022 Page 12 sur 15