Würth ISS 30-L AUTOMATIC Instructions De Service D'origine page 20

Working with power tools
DANGER
Danger of electric shock
Risk of injury and damage.
The socket is only intended for direct con-
nection of power tools to the vacuum
cleaner. Any other use of the socket is
prohibited.
1. Plug the mains plug of the power tool into the
power socket on the vacuum cleaner. The vacu-
um cleaner is in Standby mode.
2. Switch on the device at the turn switch.
Note
The vacuum cleaner is automatically switched
on and off with the power tool.
Note
The vacuum cleaner has a startup delay of up
to 0.5 seconds and an after-running time of up
to 15 seconds.
Note
See the Technical data for the permissible pow-
er rating of the power tool.
3. Remove the angle piece from the suction hose.
Figure F
4. Install the universal sleeve on the suction hose.
5. Connect the universal sleeve to the power tool.
Figure G
Automatic filter dedusting
The device is equipped with a special filter dedust-
ing function, which is particularly effective against
fine dust. The flat fold filter is automatically cleaned
every 15 seconds (AUTO 15s) or every 60 sec-
onds (AUTO 60s) by a blast of air (pulsing noise).
1. Set the turn switch to the desired program (AU-
TO 15s-AUTO 60s).
2. Power dedusting (for particularly severe con-
tamination of the flat fold filter): Set the turn
switch to program 2 AUTO 15s, seal the suc-
tion pipe or angle piece with your hand and
wait for the automatic filter cleaning to finish
(lasts 15 seconds).
Figure H
Switching off the device
1. Switch off the device at the turn switch.
2. Pull out the mains plug.
20
Each time after use
1. Empty the container.
2. Vacuum off the inside and outside of the device
and clean with a moist cloth.
Folding the push handle in/out
ISS 50 only:
1. Release the push handle lock and adjust the
push handle.
Storing the device
1. Store the suction hose and mains cable as
shown in the illustration.
Figure I
2. Store the device in a dry room and secure it
against unauthorised use.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device dur-
ing transport.
1. Remove the suction hose with floor nozzle from
the support. Carry the device by the carrying
handle and the suction pipe, not by the push
handle.
2. When transporting the device in vehicles, secure it to
prevent it from slipping or overturning in accordance
with the respective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device dur-
ing storage.
The device may only be operated indoors.
Care and service
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Dust extraction machines are safety devices for the
prevention or elimination of hazards according to
the German BGV A1.
English
Transport
Storage