Publicité
Les langues disponibles
Les langues disponibles
Hair texture
Bleached, fragile, damaged
or fine hair
Normal hair
Very coarse, thick or curly hair
•
After rolling in the hair, allow the heat to
work on the hair for a few seconds. If the
air feels too hot, set a lower temperature.
To roll out the curls, press the roll-out
button (2). The curling attachment (3) will
be disengaged and can be rolled out of the
formed curl.
•
To switch off the appliance, set the
temperature switch (1) to the "O" position.
•
Remove the mains plug from the wall
socket.
•
Allow the appliance to cool down
completely.
Hints for use
•
Use shampoo to wash your hair. If your
hair is chemically treated or damaged, use
a hair conditioner to wash your hair.
•
Dry your hair (almost fully) before curling
your hair.
•
Comb your hair out before curling your
hair.
•
Curl your hair in sections. If you have thick
hair, you must use smaller sections than if
you have thin hair.
•
If you want spiral curls, divide your hair
into small sections and move through each
section a couple of times.
•
If you want loose curls, divide your hair
into flat, larger sections and move through
each section a couple of times.
•
Shake out the curls, then style your hair
with your fingers.
•
Apply hairspray to keep your curls in place.
Use a humidity-resistant hairspray in humid
climates.
Overheating protection (fig. A)
If the air outlets are covered or if they are
blocked with hair, the emerging air will become
too hot and the overheating protection will
switch off the appliance.
•
Set the temperature switch (1) to the "O"
Recommended
position.
setting
•
Remove the mains plug from the wall
socket.
I
•
Clean the appliance. Refer to the section
"Cleaning and maintenance".
I/II
•
After five minutes, insert the mains plug
II
into the wall socket.
•
To switch on the appliance, set the
temperature switch (1) to the "I" or "II"
position.
Storage
•
Put the appliance and the accessories in
the original packaging.
•
Store the appliance with the accessories in
a dry and frost-free place, out of the reach
of children.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE
BROWN LIVE
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
Should the fuse in the BS1363 plug require
replacement, a 3Amp BS1362 fuse must be
fitted.
This is a double-insulated appliance and does
not need an earth connection.
Warning! On no account should either the live
or neutral wires be connected to the earth
terminal.
6
NEUTRAL
Publicité
