UNIPRODO UNI PBM 25 Manuel D'utilisation page 5

EN
3.1. DEVICE DESCRIPTION
1
3
2
4
5
6
1. Lever handle
2. Upper mold
3. „A" mold
4. „B" mold
5. Rotary mold base
6. Base of the machine
ACCESSORIES:
1. Cutting device
2. Metal cover
3. Transparent foil
4. Metal clasp
3.2. PREPARING FOR USE
3.2.1. APPLIANCE LOCATION
The device should always be used when positioned on
an even, stable, clean, fireproof and dry surface, and be
out of the reach of children and persons with limited
mental and sensory functions.
3.2.2. ASSEMBLING THE DEVICE
1 2
8
3
1. Prepare the base of the device.
2. The upper mold should be inserted into the hole
under the lever.
3. In the rotating base of the machine are places
described „A" and „B", in which you should
respectively insert molds „A" and „B".
3.2.3. CUTTING TOOL ASSEMBLY
1
2
3
4
1. Position locator
2. Knife
3. Knob (adjustable)
4. Handle (adjustable)
1
2
3
4
5
1. Place the blade in the handle as shown on the
picture.
2. Put the knob securing the knife blade in the right
place (as shown on the picture) and adjust it.
3. Put the position locator in the designated place.
4. The knife blade is replaceable. To replace it, break
off a piece of the blade from the technical knife
(with a broken blade).
5. Remove the screw and replace the blade.
3.3. DEVICE USE
3.3.1. PREPARING THE PATTERN
WITH A CUTTING DEVICE
1. Place the position locator on the printed (or
drawn) pattern/design. With one hand, grab the
position locator and press it against the paper,
and with the other hand, rotate the handle until
the pattern disc is cut out.
3.3.2. PREPARING BUTTONS
1. Place the metal cap in the „A" mold. Then place
the previously prepared pattern on it (cut out in
the correct size). Put a transparent foil at the end.
9 EN
2. Place the metal clasp in the „B" mold.
CAUTION! Remember that the clasp (safety pin) is
pointing downwards.
3. Move the „A" mold under the lever and press
down. All items will be in the upper mold.
4. Move the „B" mold under the lever and press down.
5. The button is ready.
3.4. CLEANING AND MAINTENANCE
a) Use only non-corrosive cleaners to clean the
surface.
b) After cleaning the device, all parts should be dried
completely before using it again.
c) Store the unit in a dry, cool place, free from
moisture and direct exposure to sunlight.
d) Do not spray the device with a water jet or
submerge it in water.
e) The device must be regularly inspected to check
its technical efficiency and spot any damage.
f) Use a soft, damp cloth for cleaning.
g) Do not use sharp and/or metal objects for
cleaning (e.g. a wire brush or a metal spatula)
because they may damage the surface material of
the appliance.