Gima FS965LH-1 Manuel page 2

All serious accidents concerning the medical device supplied by us must
be reported to the manufacturer and competent authority of the member
state where your registered office is located.
INTRODUCTION
This manual provides the instructions for a correct use of our patient aid or an
assistant / carer.
INTENDED USE
The rollator is designed to be used inside buildings by patients with an impairment
to legs.
The devices are intended to provide a support to the body. This aid allow patient
mobility making it easy to walk. They must be used with two arms in order to
guarantee safe operation.
WARNING! The rollator is built for indoor use and only on flat surfaces. If it is
necessary to employ the devices outside we advise to follow the road rules like
any pedestrian.
Before each use make sure that:
• The walker has been adjusted to the correct height.
• The tips are in good condition. Should they be worn or missing, replace them
immediately.
• Make sure that the legs of the walker have been adjusted to the same height.
MAINTENANCE
The rollator do not require special care for their ordinary maintenance. We advise
to regularly perform the following checks:
- verify the reliability of different components
- check the correct fixing of screws and nuts
- test moving parts, apply lubricant if needed
- clean parts with mild detergents (do not use corrosive or harmful chemicals),
put it in dry and ventilated environment.
WARNING!
Do not use the equipment in case it is damaged or any component is missing.
Do not use the patient aids for purposes not mentioned in this user manual.
Do not cross obstacles or use the patient aids on uneven surfaces, or wet
and slippery. The use of the device is not recommended for people with poor
functionality in the hands and arms.
Only use original accessories and spare parts. The use of non-original
accessories or spare parts could cause the risk of falls and injuries. Do not use
on stairs. The use of walkers in water (showers, bathtubs, swimming pools, etc.)
can favour the oxidation of the operating mechanisms, causing damage to the
walker and/or injury to the user.
Max load 100kg
ASSEMBLY
Figure 1
Step 1: To open folded frame assembly, follow the direction of the arrows shown
in the picture, lift the seat and place it on the support; to add the basket lift the
seat and insert the basket in the bracket, after lower the seat. Position the back
handle (7) and lock it, position the handle with braking system (2) and lock it at
the desired height shown in the picture, tighten the locknut.
ENGLISH
Figure 2
Step 2: Try to push the vehicle to check the reliability of the brake, according to
their characteristics can be adjusted as appropriate; commissioning is completed
you can use.
N° Parti
1 Basket
2 Handle with braking sistem
3 Plastic gasket
4 Removable handle
5 Hex screw
6 Seat
7 Back Handle
8 Frame assembly
Manufacturer
Consult instructions for use
Product code
Date of manufacture
Authorized representative
in the European community
Medical Device compliant with Regulation (EU) 2017/745
GIMA WARRANTY TERMS
The Gima 12-month standard B2B warranty applies.
PZ
1
2 (left and right)
2
2
2
1
1
1
Keep in a cool, dry place
Keep away from sunlight
Lot number
Medical Device
Caution: read instructions
(warnings) carefully
2