Use; Cleaning And Storage; Troubleshooting - MAXXMEE GS-4112 Mode D'emploi

Cordless LED Double Spotlights with Tripod

USE

Both spotlights (2, 14) and the joint (1)
can be oriented up to 180°.
The double spotlight can be used both
with and without the tripod.
Without the tripod it is placed on its
base (5). On a magnetic surface, the base
will also stick at an angle or upside down
because it has magnets on the bottom.
Using the Tripod
1. Loosen the 3 locking screws (10 – 12)
on the tripod.
2. Pull apart the legs (9) of the tripod
and then pull up the bottom rod (8)
until you feel resistance.
3. Tighten the bottom locking screw to
fix the legs in place.
4. Pull out the middle rod (7) and / or top
rod (6) as required.
5. Tighten the rest of the locking screws
to fix the rods in place.
6. Screw the base of the double
spotlight onto the thread at the top of
the tripod.
The tripod is collapsed in the reverse
order.
Switching On and Off
Press the switch (3) repeatedly for
a short time to switch between the
following modes:
both spotlights on
left spotlight on
Hold down the
the red flashing light. It is switched off by
briefly pressing the
01954_Inlay_de-en-fr-nl_A5_V1.indb 11 01954_Inlay_de-en-fr-nl_A5_V1.indb 11
right spotlight on
off
switch to switch on
switch.

CLEANING AND STORAGE

Please Note!
■
Disconnect the product from the
power supply before doing any
cleaning.
■
Do not use any sharp or abrasive
cleaning agents! These could damage
the surfaces.
• Wipe down the product with a soft,
dry cloth. Remove more stubborn dirt
with a damp cloth.
• Store the product in a cool and dry
place protected from direct sunlight
out of the reach of children and
animals.
• If the product is not used for a
prolonged period, charge up the
battery every three months to avoid
deep discharge.

TROUBLESHOOTING

If the product does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair the
product yourself!
The battery is not charging. The
control lamp does not light up.
The USB cable is not connected correctly
to the product or the USB mains adapter.
►
Check the connection and correct it.
The USB mains adapter is not inserted in
the plug socket correctly.
►
Correct the fit.
The plug socket is defective.
►
Try another plug socket.
EN
11
11.03.2021 13:59:35 11.03.2021 13:59:35