Skil PWRCORE 12 IF5943-00 Guide D'utilisation page 13

Using the Inflator
To Use the Digital Pressure Gauge (Fig .8)
1. Attach the battery pack onto the inflator.
2. Turn the digital pressure gauge on by
pushing the power button for more than 1
second. The inflator will detect the current air
pressure of the item.
3. Use the and
pressure, if desired. Press and hold
buttons to move down or up more quickly.
NOTE: If the current pressure item to be
inflated is greater than the target pressure, the
inflator will not begin inflation.
4. To select the desired unit of pressure, press
the and buttons simultaneously to scroll through the units of PSI, BAR and kPa.
5. To start or pause the inflation, press the start/pause button.
6. The inflator will shut off automatically when the target pressure has been reached.
CAUTION
NOTE: The inflator will shut down after 5 minutes of inactivity.
buttons to set the target
Allow the inflator to cool for 5 minutes after each 15 minutes of continuous
use.
Fig. 8
Actual
Value
or
Target Input Value
Unit
Applied
13