Skil PWRCORE 12 IF5943-00 Guide D'utilisation page 11

NOTICE: Possible air leaks can cause faulty pressure readings. Make sure all connections
are tightly secured.
NOTICE: The inflator is not designed to inflate large volume items such as boats, pools, rafts,
large air beds, etc. It is not designed for commercial applications.
Inflating with the Air Hose (Fig.3)
The air chuck on the air hose can be used
without adapters to inflate tires or other items
that have a valve stem that fit the air chuck
opening.
1. Raise the air-chuck clamp.
2. Place the air chuck on valve stem.
3. Push the air chuck down so that the
threaded section of the valve stem is inside
the air chuck.
4. Clamp the the air chuck onto the valve stem
by pressing air-chuck clamp down until it
stops or is parallel to the air hose.
5. See the instructions for using the inflator in
this manual to start inflation.
Inflating with the Air Hose and Adapters
The air hose can be used with the provided adapters to inflate a variety of items (Fig. 4).
Installing/Removing Adapters (Fig .5)
1. Remove battery pack from the inflator.
2. Raise the air chuck clamp.
3. Insert the adapter into the chuck until it stops.
4. Clamp the air chuck onto the adapter by pressing the air chuck clamp down until it stops or
is parallel to the air hose.
5. To remove the adapter: Raise the air chuck clamp up and remove the adapter from the air
chuck.
Fig. 4
Tapered
Adapter
Presta
Sport
Valve
Needle
Adapter
Adapter
Fig. 3
Air Hose
Fig. 5
Air Chuck
Clamp
Air Chuck
Valve Stem
11