Publicité
Les langues disponibles
Les langues disponibles
Maintenance and Daily Care
1. Remove the power plug prior to clean the unit. Do not clean it until the surface cools down.
2. Glass plate, panel and the shell:
(1) Soft cloth for slight stain.
(2) For greasy, dirt, blot by using a clean damp cloth with neutral detergent.
3. While the radiator-fan working, dust and dirt would remain on the gas vent, please clean it by brush or
cotton stick regularly.
4. Remember do not washing the unit by water directly to avoid damaging.
5. To protect induction cooker, be sure to have a good contact between plug and socket before using.
6. Do not pull out the power cord directly during operation. To extend the appliance's using life, press the
"ON/OFF" button first, then pull out the power cord.
7. In order to make operating time longer, the fan would still working for cooling the plate, is better to plug
out after the fan stops working.
8. Please pull out the power cord and put it away when not used for a long time.
9. Some models have structural design to against cockroaches, if needed, can put something like mothball
to expel the cockroaches.
Troubleshooting and Treatment
During operations, if any error occurred, please check the following table before calling for service. Below
are common errors and the checks to perform.
Symptoms
After connecting the
power and pressing
the"power " key, the
appliance has no
response.
Heating being interrupt-
ed in normal use and a
"Beep" will be heard.
No operation during the
heating being in use.
Error codes occur
Check points
Is the electricity in suspension?
Is the fuse broken down?
Is the plug connected firmly?
Incompatible cookware or no cookware is
used?
Is the cookware not considerably placed
form the center of the heating zone?
Is the cookware being heated but continual-
ly being?
Is the cookware empty or the temperature
too high?
Is the air intake/exhaust vent clogged or dirt
has accumulated?
Is the cooker working over 2 hours without
any external instruction?
E0 Internal circuit error
E1 Without cookware or Incompatible
cookware used
E2 Internal overheat
E3 Over-voltage
E4 Under-Voltage
E5 Top plate sensor open/short circuit
E6 IGBT sensor open circuit/short circuit
E7 Top plate overheat
Remedy
Use after resuming the electricity.
Check the root causes carefully. If the
problem cannot be fixed, please contact
Service Centrefor checking and repairing.
Replace compatible cookware for the
induction cooker.
Place the cookware at the center of the
defined heating zone.
Place a cookware inside the heating
zone.
Please check whether the appliance is
being misused.
Remove the stuff clogging the air intake/exhaust vent.
Operate the appliance again after cooling down.
Reset cooking modes or use timer function.
When showing error signal E1, E2 and
E7, please check whether the cookware
is not suitable, or switch on the appliance
again after it is cooled down naturally.
When showing E0, E3-E6, please
contact Service Center for checking and
repairing.
5
Publicité
