Product Usage; Before First Use; Use - Edenwood RCD B11 USB Consignes D'utilisation

B

Product usage

Before first use

Connect the power cable to the unit's AC socket.
Connect the power cable's plug to an appropriate mains socket.
OR
1. Remove the battery compartment cover.
2. Insert 6 batteries (not supplied) into the battery compartment, respecting the indicated
polarity (+/-).
3. Close the battery compartment lid.
NOTE:
• When the power cable is connected, the batteries will not be used.
• When the unit is being battery-operated, unplug the power cable.
• Remove the batteries from the unit whenever they are dead or are not going
to be used for a long period of time.

Use

Turn the power on or off
• After connecting the power source, the red standby indicator light will turn on. Press and
hold the
• Press the
• Whenever the unit is not used for 15 minutes in CD/USB/AUX mode, it automatically
enters standby mode. To switch the unit back on, press and hold the
NOTE:
• If the volume level on the audio source is too low, the unit may not recognise
that a device is connected and can enter standby mode. Increase the volume
level on the audio source to resume playback.
• The product can sometimes reset due to electrostatic discharge. Should this
occur, switch the unit off and back on again.
Adjusting the volume
• Press the VOL-/VOL+ button to increase or decrease the volume. Press and hold the
VOL-/VOL+ button to quickly scroll through the volume levels. The volume levels range
from VOL 00 to 32. The default volume is 12.
button to turn on the unit.
button to choose the CD/USB/FM or AUX function.
22 EN
button.