Publicité
Les langues disponibles
Les langues disponibles
To Charge T1037
a) Via Micro-USB/USB charging cable (included)
1. Insert the micro USB output of the charging cable into the T1037 & connect USB output to a wall
adapter (not included).
2. The blue LED will flash in succession to indicate that the T1037 is being charged (all 4 LED lights will
light up when the T1037 is 100% fully charged).
b) Via Type-C charging cable (not included)
1. Insert the Type-C output of the charging cable into the T1037 & connect USB output to a wall adapter
(not included).
2. The blue LED will flash in succession to indicate that the T1037 is being charged (all 4 LED lights will
light up when the T1037 is 100% fully charged)
c) Via solar lighting source
1. With solar panels facing up, place the T1037 under direct sunlight. One green LED will remain lit
while charging & remain lit once the T1037 is 100% fully charged.
NOTE: To verify remaining battery power, press power button:
4 blue LED indicates 100 – 75% battery power remaining
3 blue LED indicates 75 – 50% battery power remaining
2 blue LED indicates 50 – 25% battery power remaining
1 blue LED indicates 25 – 0% battery power remaining
To Activate Flashlight on T1037
** The T1037 has 4 built-in LEDs which gives 50 lumens per LED, for a total of 200 lumens output.
1. To activate the flashlight (solid white XM-L LED light): double-click power button
2. To activate flashing white LED light (after solid flashlight is activated): press power button again once
3. To deactivate white LED light, double-click power button
To wirelessly charge electronic devices using the T1037
** Make sure your device has integrated wireless charging capability or is equipped with wireless charging
adapter (NOTE: some electronic devices with integrated wireless capability may require users to manually
enable wireless charging in the settings of their electronic devices)
1. Center your electronic device over the wireless charging area located at the back of the T1037 (see # 9
of Product Map above) & power ON the T1037. Solid blue LED indicates the T1037 is wirelessly
charging your electronic device (NOTE: the solid blue LED will be lit while wirelessly charging your
device & automatically power OFF once your device is 100% fully charged)
2. To stop charging, remove your electronic device from charging dock (the T1037 will automatically
power OFF when inactive for approx. 60 seconds)
To charge electronic devices using the T1037 with charging cable
a) Via USB/micro-USB charging cable
1. Insert the following cable into the T127 USB output:
To charge Android devices: use the micro-USB/USB cable included with the T127.
i.
Publicité
