Genesis GCD18BK Manuel D'utilisation page 10

OPEraTiOn
Warning:
follow all important safety warning and instructions before using this
tool.
nOTE:
always Check that the power supply corresponds to the voltage
on the ratings plate.
Charging the tool (FIG 2)
• use only the Battery Charger that is included in this kit to recharge your batteries.
• use only 120 Volt AC Power Source.
• Charge your batteries fully before using the drill for the first time.
• Connect the wall adaptor (2) to charger stand (3)
• Plug the wall adaptor (1) into a 120 Volt AC Power Source.
The red light on the charger will illuminate, indicating the
charger is power on.
• Insert the battery (1) into the slot on the charger stand
(3). Make sure that the battery is seated firmly in the
charger. The green light on the charger will illuminate,
indicating that the battery is charging.
• Charge for 3 hours before initial use, and after normal
use. If drill has been used continuously, and the battery
is completely discharged, it may require up to 5 hours to
fully recharge the battery.
• The green and red lights will remain lit, even after charging is complete.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the drill, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
• Other tips for extending battery life: Do not store batteries completely discharged. Charge them
fully before storing, and if drill is not used for a long time, take the batteries out and charge them
periodically.
Warning:
in the locked or off position before any assembly, adjustments or changing
.
accessories
Warning:
or removal of the battery pack
Installing or Removing the Battery Pack (FIG 3)
• To install the battery pack, insert the battery pack into
drill housing as shown in fIG 3. Always insert it all the
way until it locks in place with a little click. Lightly pull on
the battery to ensure it is locked into place and will not
accidentally fall out of the drill, causing an injury.
• Do not use force when inserting the battery pack. If the
battery does not slide in easily, it is not being inserted
correctly.
• To remove the battery pack, withdraw it from the tool
while depressing the tabs (1) on both sides of the battery
pack.
18V Cordless Drill/Driver
Operator's Manual
To reduce the risk of serious personal injuries, read and
always disconnect battery pack from tool or place the switch
always be sure that the tool is switched off before insertion
.
3
2
1
Fig 3
1
GCD18BK
Fig 2