Pl-Fiber Tray Installation - Miranda picoLink Serie Notice D'installation Et D'utilisation

3.5 PL-Fiber tray Installation

PL-Fiber-tray is equipped to house up to 10 pico fiber with dual power supply for redundancy.
Figure 4 : PL-Fiber-tray front view
1. Insert pico fiber in the corresponding housing, with SC/PC fiber connector to the front.
Attention Status Led is located at the rear of the pico (BNC side)
Caution: Although not considered overly dangerous for the eye, avoid accidental
exposure to the optic beam emitted from the fiber optic connectors.
2. The clip of the SC/PC connector is used to fasten the pico module
3. Connect the power cord on the 3 pins power socket
Figure 5 : Pico fiber housed in a tray
7
FEO-171p
Pico fiber power supply
connection