Publicité
Les langues disponibles
Les langues disponibles
Steam function setting:
After power on, set temperature control dial to steam ironing position. Heating the indicator light on an iron
unit lights up to indicate the unit being heated up. When desired temperature has been reached, heating in-
dicator light turns off, it is ready for using. During use, heating indicator light will cycle from ON to OFF and
then OFF to ON, it indicates that the iron is automatically heat preservation. Press steam button to start steam
ironing. When you adjust the temperature control dial, steam rate will be adjusted accordingly. MAX steam will
be obtained when set at MAX position, it will be smaller gradually when turn to WOOL/SILK
position.
Note: When temperature control dial is located at SYNTHETIC , it is proposed not to activate steam ironing
since temperature is too low to produce steam, it only suits for dry ironing,
Steam Ironing
1. Fill water tank with clean tap water.
2. Connect the unit into a suitable main socket. Turn temperature control dial to steam ironing position.
3. Before first time use of steam ironing, please clean the iron as below methods: Take the iron unit up from
the base unit, press steam button underneath the handle to allow steam release for 30 seconds and then
stop for 30 seconds, do so as a cycle, and repeat above cycle again. The iron is not ready for using until the
heating indicator light turns OFF.
4. During steam ironing, steam rate will be varied when temperature control dial is adjusted to different posi-
tions. This can prevent water leakage caused from soleplate.
5. After using, take the iron unit back onto base unit,turn temperature control dail to ¨MIN , and then unplug
from main socket. Slide water tank out from the base unit and empty it.
NOTE: For every first time use, it is normal thatˇs a slightly vibration sound may be occurred from electrical pump
inside the base unit for a few seconds when steam ironing started. If this abnormal conditions coutinuously hap-
pen for more than 60 seconds, please check whether water tank and filter assembled correctly or not.
Vertical steam ironing:
Follow the steam ironing process, and then hold the iron in vertical position between 5cm and 15cm away from
the hanged fabrics. Press down steam switch, this will create vertical steam. This feature is especially used for
removing creases from hanging clothes and curtains. Never directly perform steam ironing on people. (Fig.8)
Handle
Handle attached to the
base unit used to carry the
appliance. Before use, press
down two handle buttons
synchronously, and then lay
the handle down. (Fig.9) Af-
ter use, allow the appliance
completely cool down, be-
fore you lift handle up until
a ¨pa sound is provided.
11
Publicité
