WilTec SK-30 Guide D'utilisation page 11

CAUTION: The pump shaft can not be removed. IF THE PUMP FAILS TO OPERATE, CHECK THE
FOLLOWING:

Check the circuit breaker and try another outlet to ensure the Skimmer is getting electrical power.
NOTE: Always disconnect from electrical outlet before handling the Skimmer.

Check the Skimmer discharge and tubing for kinks and obstructions. Algae build up can be
flushed out with a garden hose.

Check the inlet to ensure it is not clogged with debris.

Remove the skimmer inside pump inlet to access the impeller area. Turn the rotor to ensure it is
not broken or jammed.
Monthly maintenance will add to your Skimmer's life. NOTE: Ensure that the electrical cord loops

below the electrical outlet to form a "Drip Loop" This will prevent water from running down the
cord into the electrical outlet.
Figure 2
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Suction holder
Seite 11