Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
• To avoid dangerous overheatings, it is recommended:
to unroll the power cord for it's whole length and to use the appliance as
advised in the "FUNCTIONING" paragraph.
• To avoid overheatings do not let the appliance work for more than 3
consecutive cycles each of which of the maximum duration of 1 minute
(inserting pauses of at least 2 minutes).
Since it has to perform processing in sequence or in longer times, perform
a pause of at least 15 minutes once the 3 consecutive cycles are over.
• Do not leave the appliance unnecessarily inserted. Disconnect the plug
from the mains power supply when the appliance is not used.
• Do not obstruct the ventilation and heat elimination openings or fissures.
• If the power cord of this appliance is damaged, it must be changed
exclusively by a technical assistance centre authorized by the manufacturer,
since special tools are necessary.
The electrical safety of this appliance is guaranteed only when
it is correctly connected to an effective grounding system as
specified by the current norms on electrical safety.
• It's necessary to check this fundamental safety condition and, in case of
doubts, ask for an accurate check of the system by professionally qualified
personnel.
The manufacturer cannot be considered liable for possible damages
caused by the lack of grounding of the system.
• Before carrying out any operation turn off the appliance and disconnect the
power plug from the outlet and wait for the appliance to be completely cooled.
• Don't connect the appliance to the power supply through external timers
or remote control systems.
☞
Make sure that the power cord do not protrude from the bearing
plane in order to prevent that someone could, even inadvertent-
ly, pull it toppling the appliance.
46
GENERAL WARNINGS
CHO 6615
Publicité
Table des Matières
