Publicité
Les langues disponibles
Les langues disponibles
Monitor:
A. Wind Chill & Heat Stress Temperature Index Scale
B. Humidex/Heat Index
C. Wind Chill & Wind Speed
D. Indoor & Outdoor Temperature
E. Outdoor Relative Humidity
1. Max/Min Button
2. Heat Index/Humidex Button
3. Wind Speed/Wind Chill Button
4. In/Out Temp Button
5.
º
C/
º
F Button
6. Reset Button
1.0 Set up Procedure
1. Pull away the water proof casing of
the transmitter to reveal the battery
compartment.
2. The attached cable of the wind
sensor will be in the corresponding
socket on the transmitter.
3. Remove the battery cover from the
monitor located on the back of the unit
and insert 2 x AA, 1.5V Alkaline batteries.
4. Remove the battery cover from the
transmitter located below the socket and
insert 2 x AA, 1.5V Alkaline batteries and
close the cover.
Every time the transmitter is powered up (for example after a change of batteries),
the LED indicator will light up for 4 seconds (if no LED lights up or if the light stays
on permanently, make sure the battery is inserted correctly). After the transmitter is
powered up, the sensor will start to transmit regular outdoor temperature, relative
humidity and wind speed measurements.
NOTE: Each time the transmitter is powered up, a random security code will be
generated to distinguish itself from other transmitters around. If a battery change has
been made in the transmitter, the receiver must be reset so that the new security
code can be re-registered again.
2.0 Mounting
Before mounting the two units permanently ensure the units are working properly.
Wireless Wind Chill and Humidex Thermometer
Instruction Manual
LED Indicator
Sensor Socket
Battery
Compartment
Transmitter
7. Wind Sensor
8. Remote Sensor
Battery
Cover
3
Publicité
