Dometic MK140 Instructions De Montage Et De Service page 9

MK140
6 Connecting the device
!
CAUTION!
The 230 V connection cable must have a cross-section of
2.5 mm².
A
NOTICE!
 Make sure that there is a correctly installed, 15 A fuse between
the positive terminal (+) of the battery and the device.
If there is no adequate and correctly installed fuse, the device
may be damaged and the guarantee will be voided.
 When connecting the battery and the 12 Vg consumer unit,
make absolutely sure that the polarity is not reversed.
 When connecting the consumer unit, make sure that the per-
missible power load is not exceeded.
➤ Open the cover for the connections by turning the lock (fig. 1 6, page 3)
anti-clockwise using a screwdriver.
➤ Remove the cover (fig. 1 5, page 3).
➤ Connect the device:
No. in
fig. 2, page 3
1
2
3
4
5
6
7
8
➤ Secure all cables leading in and out of the device using strain relief
clamps (fig. 2 8, page 3).
➤ Cover the connections with the cover (fig. 1 5, page 3).
EN
Element
230 Vw output
230 Vw input (external voltage supply)
Equipotential bonding
Slot 1: Battery (+12 Vg) connection
Slot 2 – 6: Earth connection
Slot 7 – 9: 12 Vg output, unfiltered
Slot 10: 12 V, 1 A output, filtered, short-circuit-proof
Cable strain relief
Connecting the device
9