Publicité
Les langues disponibles
Les langues disponibles
If you get a flat tyre:
-
The tyres are repaired as for bike tyres.
-
Remove the inner tube and repair it with a
patch.
-
Run your finger round the inside of the tyre to
ensure no sharp object (e.g. the tip of a thorn)
remains stuck in the tyre.
-
Replace the inner tube, then the wheel and
pump up the tyre.
-
If the inner tube is too damaged, replace it. (A
new one is included in the maintenance kit).
ADJUSTMENTS TO THE FRONT WHEEL DISC BRAKE
If ...
GB
The wheel
turns slowly
The disc
brake
does not slow
down the
wheel
properly
The brake
lever on the
handlebar is
stiff
39
Possible causes
The wheel is not
Check that the wheel axle is placed well into the fork. If
in the axle
it is not, adjust the axle then lightly retighten the nut.
Loosen the nut on the axle until the wheel turns without
The wheel axle is
difficulty. PLEASE NOTE: There should be resistance
too tight
when you lower the quick release lever otherwise you
may lose the nut on the axle during use.
On the pad near the fork - tighten or loosen the red
The disc rubs
washer (8a) to adjust the brake and to leave only a
against the brake
minimum amount of space between this pad and the
pad(s)
disc.
Using the Allen key provided with the axle, loosen
The spring on the
the bolt on the cable by lightly unscrewing the bolt
brake cable is too
situated just below the bolt (12), then retighten.
tight
PLEASE NOTE: The cable must always be taut.
On the pad near to the fork: Unscrew the red washer
(8a) to move the pad forward, leaving only a minimum
One or both brake
amount of space between this pad and the disc. On the
pads are slightly
pad located near the front wheel spokes: Use the Allen
worn
key provided with the axle to lightly unscrew the pad
(8b), bringing it nearer to the disc.
The pad is
Contact your stockist to order a new set of brake pads.
completely worn
The brake cable is
Untighten the nut which is next to the brake lever (11).
too tight
When walking on rough, stony ground or in
the countryside, watch out for thorny bushes.
-
If you often get a flat tyre, it may be that you
need to increase the pressure in the tyres. You
can pump them up to a pressure of 1,8 kgs..
Your stroller «pulls» to one side:
-
Check that all 3 tyres are at the same pressure.
You find it hard to fold your stroller:
-
After cleaning the catches (44), (seen on the
inside of the aluminium chassis when folding)
apply some drops of silicone or liquid spray
(available in DIY shops) as shown.
Suggested solutions
Publicité
