BUXTON BAA 100 Mode D'emploi page 3

Note 6: Do not throw the adapter in fire or water.
Pairing
Pairing a new Bluetooth device
While the device is off, press the on / off button for 5 seconds. Alert "POWER ON" sounds. Once as the LED
flashes alternately red and blue, "PAIRING" alert sounds and the receiver waits for the connection. Enter the
Bluetooth menu, item Setting of the connected device and search for "BUXTON BAA".
Based on the OS version of the attached device, you may be prompted to enter the "0000" password.
Once the pairing has been successful, the "Connected" alert sounds. LED indicator flashes slowly blues
(once every 3 seconds). The device turns off automatically if there is no successful pairing with any Bluetooth
device within 5 minutes.
Warning: Before pairing the adapter, make sure that the volume of your BT device is minimized to prevent
possible damage to the device.
Disconnecting a Bluetooth device
In pairing mode: Press and hold the On / Off button for 1 second, the "Disconnect" alert sounds. The LED
indicator flashes alternately red and blue and the device waits for a connection.
In Disconnect mode: Press and hold the On / Off button for 1 second, the "connected" alert sounds. LED
indicator flashes slowly blues (once every 3 seconds). The receiver connects to the previous device.
Disconnect
When the connected device disconnects Bluetooth or is out of range, the receiver automatically switches
to pairing mode and waits for a connection. If the receiver is not connected to any device, it automatically
turns off within 5 minutes.
Warning:
– Do not use the adapter with connected headphones for extended periods at a higher volume. It may
cause irreversible hearing damage.
– Do not use the adapter with connected headphones while driving, cycling, or in other situations where
rapid reaction is required or where there must not be limits in the reaction to the environment.
Technical specifications
Bluetooth version
Supported Bluetooth profiles
Maximum range
Battery 110 mAh (Li-polymer battery with protective circuit against overload and short circuit).
Charging voltage
Power connector
Adapter charging time
Music playback time
Call time
Time in standby mode
Sensitivity
Frequency range
Adapter dimensions
Adapter weight
* The operating times listed above may vary depending on the set operating mode and the adapter settings.
Note: Technical specifications are subject to change without prior notice.
Warning: The manufacturer is not liable for damages caused by incorrect use of the product.
Instructions and information on handling the used packaging
Take the used packaging material to the municipal waste disposal.
Disposal of used electric and electronic devices
This symbol on products or original documents means that used electrical and electronic products
should not be treated as regular household waste. For proper disposal, recovery and recycling of
3 EN
HFP, HSP, A2DP, AVRCP
Micro USB (USB 2.0)
up to 8 hrs. (at medium volume) *
up to 10 hrs. (at medium volume) *
up to 120 hrs. *
92 ± 3 dB (at 1 kHz)
20 – 20,000 Hz
60 × 14,5 × 12,5 mm
V5.0
≤ 10 m
5 V / 1 A
≤ 2 hours
11 g