Under Table Guard Screw; Table Leg; Switch Box - Ryobi A25RT03 Manuel D'utilisation

ASSEMBLING THE ROUTER TABLE
Assembling the router table involves attaching the switch
box, the under table guards, the legs, the router/insert plate
assembly, the fence assembly, featherboard, throat plate,
starting pin, and installing the miter gauge to the router table.
ATTACHING THE SWITCH BOX
See Figure 5.
The switch box will come with the screws and nuts attached.
Use these screws and nuts to attach the switch box to the
table.
 Loosen and remove the screws and nuts from the switch
box.
 Place the router table upside down on a flat surface.
 Hold the switch box so that the words ON and OFF on
the toggle switch are upside down.
 Line up the three holes in the switch box with the three
holes on the outside of the front rail, this is the rail that
is already installed on the front underside of the router
table.
 Insert the switch box screws through the holes in the
switch box and through the holes in the front rail.
 Install the nuts on the back of the switch box screws.
 Holding the screws in place with a screwdriver, tighten
the nuts onto the screws with a wrench or socket.
ATTACHING THE UNDER TABLE GUARDS
See Figure 6.
Remove the under table guard screws from the blister pack.
Use these screws to attach the under table guards.
 Place the router table upside down on a flat surface.
 Position the under table guards in front of and
the insert plate area. The front under table guard should
have the open ended side facing the back of the router
table.
 Align the three holes of the under table guards with the
holes in the table. The front under table guard will be
bolted through the front rail and in to the table.
 Insert the under table guard screws through the holes
and into the table.
 Tighten screws with a screwdriver.
ATTACHING THE TABLE LEGS
See Figure 7.
Remove the table leg screws from the blister pack. Use these
screws to attach the table legs.
 Place router table upside down on a flat, level surface
with the front edge closest to you.
 Place each leg in a corner of the table. The legs with the
warning labels should go in the front, and the legs without
the warning labels should go in the back.
ASSEMBLY

SWITCH BOX

SCREW
UNDER
TABLE GUARDS
behind
FRONT RAIL

TABLE LEG

RIGHT LEG-
FRENCH / SPANISH
LABEL
10 - English
SWITCH KEY
SWITCH BOX
FRONT RAIL
UNDER TABLE
GUARD SCREW
TABLE LEG SCREW
FRONT SIDE
LEFT LEG-
ENGLISH LABEL
SWITCH
BOX NUT
Fig. 5
Fig. 6
Fig. 7